GE JVW5361SJSS Manual de Instruções descarregar pdf (Página 3)

31-10983

3

INSTALLATION PREPARATION

Installation Preparation

POWER SUPPLY

IMPORTANT – (Please read carefully)

WARNING:

FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE

PROPERLY GROUNDED.

Remove house fuse or open circuit breaker

before beginning installation.

Do not use an extension cord or adapter plug

with this appliance. Follow National Electrical

Codes or prevailing local codes and ordinances.

Electrical supply

These vent hoods must be supplied with 120V,

60Hz, and connected to an individual, properly

grounded branch circuit, and protected by a 15

or 20 amp circuit breaker or time delay fuse.

• Wiring must be 2 wire with ground.

• If the electrical supply does not meet the above

requirements, call a licensed electrician before

proceeding.

• Route house wiring as close to the installation

location as possible in the ceiling or wall.

• Connect the wiring to the house wiring in

accordance with local codes.

Grounding instructions

The grounding conductor must be connected to

a ground metal, permanent wiring system, or an

equipment-grounding terminal or lead on the hood.

WARNING:

The improper connection

of the equipment-grounding conductor can result

in a risk of electric shock. Check with a qualified

electrician or service representative if you are in

doubt whether the appliance is properly grounded.

ADVANCE PLANNING

Duct Install Planning

• This hood is designed to be vented vertically

through the ceiling. Use a 6" round duct. Use

locally supplied elbows to vent horizontally

through the rear wall.

• Use metal ductwork only.

• Determine the exact location of the vent hood.

• Plan the route for venting exhaust to the

outdoors. To maximize the ventilation

performance of the vent system:

1. Minimize the duct run length and number of

transitions and elbows.

2. Maintain a constant duct size.

3. Seal all joints with duct tape to prevent any

leaks.

4. Do not use any type of flexible ducting.

• Install a wall cap or roof cap with damper

at the exterior opening. Purchase the wall or

roof cap and any transition and length of duct

needed in advance.

• When applicable, install any makeup

(replacement) air system in accordance

with local building code requirements. Visit

GEAppliances.com for available makeup air

solutions.

Recirculation Install Planning

A recirculation duct (included) and two

charcoal filters (not included) are necessary for

recirculation installation.

Power Supply Planning

The location of the power supply connection is

called out in the Prepare the Wall section on

page 6.

1 2 3 4 5 6 7 8 ... 15 16

Comentários a estes Manuais

Sem comentários