Ge MONOGRAM ZV900 Manual do Utilizador

InstallationInstructions36″ Glass CanopyChimney Vent HoodZV90049-8032804-06 JR

9INSTALL FRAMING FOR HOODSUPPORTIMPORTANT— Framing must be capable ofsupporting 100 lbs.If drywall is present, mark the screw hole locations forthe to

Installation InstructionsINSTALL DUCT BRACKETThe duct bracket should be installed against theback wall and flush with the ceiling. This bracket willho

11Installation InstructionsPREPARE THE HOOD• Place the hood on a padded surface.• Position the motor housing at the back of the hood.Electrical connec

CONNECT DUCTWORK• Install ductwork, making connections in thedirection of airflow as illustrated.• Push duct over the exhaust outlet and damper.• Secu

13Installation InstructionsINSTALLATION—VENTED TO THE OUTSIDECONNECT ELECTRICALVerify that power is turned off at the source.WARNING:If house wiring i

INSTALL DUCT COVERS• Place the decorative ductcovers on top of the hood.NOTE: The inside (upper) duct piece has holes on oneend. The holes are intende

15Installation InstructionsINSTALLATION—RECIRCULATINGDUCTWORK, WIRING LOCATIONS• Determine the exact location of the vent hood.• Locate the template p

Installation InstructionsINSTALLATION—RECIRCULATING16INSTALL DUCT BRACKETThe duct bracket should be installed against theback wall and flush with the

17Installation InstructionsINSTALLATION—RECIRCULATINGPREPARE THE HOOD• Place the hood on a padded surface.• Position the motor housing at the back of

CONNECT ELECTRICALVerify that power is turned off at the source.WARNING:If house wiring is not 2-wire with a ground wire, a ground must be provided by

14-5/8″to top ofbracketCL▼ALIGN BOTTOM EDGE WITH PENCIL LINE, INDICATING BOTTOM OF THE HOODDrill 2 (two) 3/16″ pilot holes through studs or rear wall

19Installation InstructionsINSTALLATION—RECIRCULATINGINSTALL FILTERSIMPORTANT: Check to be sure that the mainON/OFF switch next to the motor is in the

Printed in ItalyNOTE: While performing installations described in this book,safety glasses or goggles should be worn.For Monogram®local service in you

Safety Information2BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT— Save these instructions forlocal inspector’s use. • I

INSTALLATION OPTIONSNOTE: Installation height should be measured from thecooking surface to the outer glass sides.This hood may be installed onto a wa

Installation Preparation4ADVANCE PLANNING• Determine the exact location of the vent hood.• Plan the route for venting exhaust to the outdoors.• Use th

DUCT FITTINGSUse this chart to computemaximum permissible lengths forduct runs to outdoors.NOTE: Do not exceed maximumpermissible equivalent lengths!M

Installation PreparationREMOVE THE PACKAGINGCAUTION: LIFT THE HOOD OUT OF THE BOXBY THE CENTER METAL PORTION. DO NOT LIFT BY THEGLASS SIDES.PRUDENCE :

7Wall Mount ZV900Installation HeightsActual *PossibleCeiling *Possible VENTED RECIRCULATINGHeight Installation Height Installation Height7′ 11″ 24″ to

CHECK INSTALLATION HARDWARELocate the hardware accessory box packed with the hood and check contents.Installation Preparation29-7/8"11-1/2"1