GE 45130 Manual do Utilizador Página 1

45130ChoiceALERTChoiceALERT™Control all Sensors & accessories from one location™Wireless Alarm SystemGarage Door SensorUser’s Manual

1011Note: The sensor has a LED that flashes to show when the sensor has triggered and transmitted to the main unit. Step 4 - When testing is complete,

1011Note: The Sensor detection system is ‘range dependant’, which means Sensors located closer to the Control Center may seem to have batteries that l

1213Garage Door Sensor F.A.Q.’SQ. I bought a new Sensor and the Control Center will not recognize it. Why?A. First, make sure that the yellow batter

1213Q. Why does one of my Zones continually flash?A. This can be caused by 1 of 2 conditions. First condition, if it is a rapid flash it means a Sens

1415FCC WarningAny unauthorized changes or modifications to the equipment would void the user’s warranty and may conflict with both state and federal la

1415WARNINGLimitations of Alarm ProductsThis product should be tested periodically to make sure it is working properly. The product, if used properly,

is a trademark of the General Electric Company and is used under license to Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, O

23Important Safeguards 4Introduction 5Installation 6Assigning a Sensor to a Zone 7-8Erasing a Sensor from a Zone 8-9Testing a Senso

23Before connecting or operating the Garage Door Sensor, please read these instructions carefully and save this manual for future reference.Congratula

45Important safeguardsPreCautions1. Do not attempt to disassemble the Garage Door Sensor, unless described in the user’s manual. There are no user ser

45IntroductionThe Garage Door Sensor is designed to be used specifically with vertical opening garage or shed doors. When mounted properly it monitors

67Preparing the Garage Door Sensor for InstallationThe Garage Door Sensor is a self-contained Sensor. Before installing open the battery door and, rem

67bottom edge of the Garage Door Sensor even with the door edge. In most applications you can use double sided tape (included). It is strongly sugges

89Follow these steps to assign a Sensor to a Zone. Step 1 – Press and hold the Learn button on the Control Center for three seconds. When the C

89 Learn button on the Control Center. The unit will beep once. Step 2 - While holding the Learn button, press and hold the Zone button to be