GE ALC4 Guia de Instalação descarregar pdf (Página 2)

Choose a mounting method: chain, cable, rod or surface mount.

Chain Cable Rod Surface

Hang up to two chains, cables or rods from a structural member of the

ceiling to support each xture. Fixture must be supported independently

of an outlet box. Install mounting brackets for each xture.

Unit Installation

Please follow all UL, NEC and minimum load rating guidelines

when selecting and installing a chain, cable or rod.

Mounting bracket (with #6-3/8” Phillips

head screws) and xture shown.

Position mounting bracket in

desired location.

Fit one side of the bracket into an

extrusion slot on the xture.

Fully tighten screws to lock in

place and strengthen the bracket.

Squeeze the mounting bracket and

press down until it snaps into place.

Fixture is now ready to install with

chain, cable or rod. If installing a

Continuous Run or Control Module,

please review additional instructions

later in this publication.

Mounting Bracket Installation

ALC4 Fixture Weight

120-277V 347/480V

4 ft. xture 8.5 lbs. 11.5 lbs.

8 ft. xture 17 lbs. 20 lbs.

The mounting bracket can be installed at any location along the length of the xture. Screws must be fully tightened to lock in place

and strengthen the bracket. Each mounting bracket can connect to a chain, cable or rod.

Carefully unpack unit and properly inspect for defects before installing. Wear work gloves to prevent dirt and oil from being

transferred to the luminaire.

1 2 3 4 5 6

Sem comentários

GE ALC4 Guia de Instalação Página 2