GE EFNA Guia de Instalação descarregar pdf (Página 2)

MOUNTING

WARNING

Risk of injury or damage. Unit will fall if not installed

properly. Follow installation instructions.

HANDLING

• This luminaire has been properly packed so that

no parts should have been damaged during transit.

• Inspect to conrm.

• Damage may occur if luminaire is improperly

handled outside of pack.

• Do not impact or stack luminaire after removal

from packaging.

• Open wiring compartment cover located on the

mounting bracket. Make electrical connections and

close wiring compartment cover.

Note: Make all electrical connections in accordance

with the National Electrical Code and any applicable

local code requirements.

UNPACKING

• Open Wiring compartment cover located on the

mounting bracket. Make electrical connections and

close wiring compartment cover. Seal wall mounting

ange to the mounting surface with silicone, caulk,

or equivalent.

3. Trunnion Mounted Units: Mount directly on a

at surface. The Trunnion bracket has a clearance hole

for a 3/4-inch bolt used for attachment. Tighten side

trunnion bolts to 15-20 foot pounds.

• Connect xture supply leads inside of customer

supplied junction box.

Note: Make all electrical connections in accordance

with the National Electrical Code and any applicable

local code requirements.

FIGURE 1

Set Screws

Follow Installation Instructions

1. Pipe Mounted Units:

The sliptter can be mounted

on 1-7/8-inch O.D. through 2-3/8-inch O.D. or 2-7/8 O.D.

through 3-inch O.D. pipes. Set screws are used to clamp

the oodlight security to the pipe. Tighten set screws to

15 foot-pounds (20.3 N•m). Sliptter is designed to mount

on a vertical pipe pointed upward such that gravity acts

to hold oodlight in place while the set screws are

tightened. Do not mount unit up-side-down.

2. Wall Mounted Units: The wall mounting plate

is provided with four .438-inch clearance holes spaced

4.375(H) x 2.875(V) inches for mounting. Do no mount

the unit such that the hinge side of door is higher than

the latch side of door.

FIGURE 2

2.875 in.

4 Holes

.4387 in.

4.375 in.

AIMING

1. Downward Aiming: On any orientations where

the glass is facing downward, remove the two power

door drain hole screws.

IMPORTANT: make sure all four rear drain holes are in

place on downward orientations

FIGURE 3

Remove Drain Screw

for downward position

Drain Screw remain

for downward position

1 2 3 4 5 6 7 ... 11 12

Comentários a estes Manuais

Sem comentários

GE EFNA Guia de Instalação Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com não GE EFNA