GE EPST Guia de Instalação descarregar pdf (Página 2)

• NOTE: Make all electrical connections in accordance

with the National Electrical Code and any applicable

local code requirements.

• NOTE: Verify that supply voltage is correct by

comparing it to nameplate.

Standard Mounting

• Remove cover at base of unit and connect all 3 power

leads to the terminal block.

• Replace cover.

Pendant Mounting

• Remove one screw to open the top of the xture.

Allow the bottom to hang from it’s hinges.

• Pull the wires into the top housing.

• Connect all 3 power leads to the terminal block in the

top housing.

• Close top and replace the latch.

WIRING

UNPACKING

MOUNTING

• This luminaire has been properly packed so that no

parts should have been damaged during transit.

• Inspect to conrm.

WARNING

Risk of injury or damage. Unit will fall if not installed

properly. Follow installation instructions.

WARNING

Risk of injury. LED light source achieves full intensity

immediately upon being powered on. Do not look

directly at LED light source while energized during install.

Standard Mounting

• This luminaire is provided with means for mounting on

3-inch (76mm) max. outside diameter pole tops.

• Feed the power supply leads through the sliptter wire

access hole as the xture is installed on the pole.

• Orient canopy screw or latch toward street and level

by adjusting the 3 screws, and tighten.

• Caution: Tighten screws to 15 - 20 ft-lbs (20-27 N-m).

• Remove shipping ties from wire way in the rear upright.

Pendant Mounting

• Use 1 1/4 inch pipe for Pendant.

• Insert the pendant pipe through the cupola.

• Apply an appropriate pipe sealant to the end of the

pendant pipe.

• Turn the pendant pipe into the 1 1/4 inch pipe tting

on top of the xture.

• Orient the xture so that the house side faces the

proper direction.

• Tighten the top set screw on the pipe tting.

• Fit the cupola onto the top housing of the xture.

• Tighten the 3 cupola screws.

Customer Pendant

Apply pipe sealant to

this joint

Set Screw

Cupola

Pipe Fitting

Cupola Screws (3)

Latch Screw

Latch

GE_GEH6005A_LED_Evolve_EPST_PostTop_Salem_Installation_FINAL_091113.indd 2 9/11/2013 9:52:55 AM

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

GE EPST Guia de Instalação Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com não GE EPST