GE EWSW & EESW Guia de Instalação descarregar pdf (Página 2)

MOUNTING

WARNING

Risk of injury or damage. Unit will fall if not installed

properly. Follow installation instructions.

• Removethebackcoverbylooseningthetwosecurity

 screwsandslidingthecoverdownwardoofthe

hinges.

• Agasketisprovidedonthebackoftheunittoprovide

water and dust protection when mounting to smooth

surfaces. To maintain IP65 dust and water protection

MAINTENANCE / CLEANING

FIGURE 1

• This luminaire has been properly packed so that no

parts should have been damaged during transit.

• Inspecttoconrm.

UNPACKING

OUTLET BOX MOUNTING

• Theluminairecanbemountedtoasuitablerecessed

 mountedoutletbox(31/2-in.or4-in.octagonal).

• Thebackcovermaybeattachedtotheoutletbox

 withtwo10-24screws(notprovided),approximately

 1”(25mm)long.

• Analternatemethodofmountingthebackcoverover

 arecessed-mountedoutletboxistopositionback

 coverovertheboxandsecurelymountwithlagbolts

(not provided) through the holes provided in the back

cover (see Figure 1).

WARNING

Risk of electric shock.Makecertainpowerisobefore

attempting any maintenance.

• Tomaintainhigheciencyofthelens,occasional

cleaning of the outer lens surface may be needed,

 withfrequencydependantonlocalconditions.

• Use a mild soap or detergent, which is essentially

 neutralpH(pHapproximately6to8),nonabrasive,

and which contains no chlorinated or aromatic

hydrocarbons.

• Wash thoroughly, using a soft cloth.

• Rinse with clean, cold water and wipe dry.

HANDLING

• Damagemayoccurifluminaireisimproperlyhandled

outside of pack.

• Donotimpactorstackluminaireafterremovalfrom

package.

 oftheunitontexturedsurfaces(block,brick,etc),

caulk the back of housing with generic non-hardening

sealant (not provided) across the top, bottom and

both sides.

• Pullwiresfromoutletboxintothecover

• Attachthecovertothewalloroutletusingtheholes

in the cover as a drill template. Alternately, the

mounting diagram in these instructions may be used

as a drill template.

• Slidextureontothecoverhinge.

• Connectwires.

• Closethextureandsecurewiththetwosecurity

screws.

STORAGE

• Prior to installation, units should NOT be stored

 outsideincorrugatedboxes(cardboardboxes)alone.

• Untilinstallation,allunitsshouldbeplacedina

covered dry storage area. The storage area should

 notexceed-40°C(-40°F)to50°C(122°F).

- This can be preferably in a roofed area or with a

tarp that is secured in such a way to keep water

  oofthecorrugatedboxes(cardboardboxes).

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

GE EWSW & EESW Guia de Instalação Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com não GE EWSW & EESW