GE W25C Guia de Instalação descarregar pdf

GEH-3767F

Wallighter 250/400 Luminaire

INSTRUCTIONS

READ THOROUGHLY BEFORE INSTALL-

ING

MOST DWELLINGS BUILT BEFORE 1985 HAVE

SUPPLY WIRE RATED 60°C. CONSULT A

QUALIFIED ELECTRICIAN BEFORE INSTALLING.

GENERAL

This luminaire is designed for outdoor lighting service,

and should not be used in areas of limited ventilation, or

in high ambient temperature enclosures. Best results will

be obtained if installed and maintained according to the

following recommendations.

This luminaire is designed for vertical-surface mount-

ing to illuminate underpasses or the ground around

buildings, or it can be mounted horizontally facing upward

to light signs or walls. It is for use only in non-hazardous

locations, where submersion by water is impossible, and

should not be mounted within easy reach of the general

public. A special vandal shield is available for vertical-

mounted units up to 250 watts.

UNPACKING

This luminaire has been properly packed so that no part

should have been damaged during transit. Inspect to

confirm.

INSTALLATION

To install, follow the steps below:

1. Remove the refractor/door assembly from carton.

2. Remove the reflector by loosening the center screw

and lifting up on reflector, thus exposing the polar-

ized socket connector.

3. Disconnect the polarized socket connector.

4. Place refractor/door assembly and reflector back in

the carton to prevent damage.

The unit is now ready for mounting and wiring.

FLAT SURFACE MOUNTING

Four knock outs – 3 mounting holes and 1 wiring

entrance hole in triangular array – are provided through

the rear wall. (See Fig. 1.) (See Fig. 2 for additional

dimensions.)

Note: Back of luminaire must be caulked with a

generic non-hardening sealer across the top and

down both sides.

Fig. 1 - Rear view showing wall mounting dimensions

CAUTION

Unit will fall if not installed properly

• Follow installation instructions

WARNING

Risk of electric shock

• Turn power off before servicing

– see instructions

WARNING

Risk of fire

• Use supply wire specified on

nameplate

These instructions do not purport to cover all details or variations in equipment nor to provide for every possible contingency to be met in connection with installation, operation

or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s purposes, the matter should be

referred to GE Lighting Solutions.

Lighting Solutions