GE ABV1 Guia de Instalação descarregar pdf

Lighting

Installation Guide

imagination at work

Modular High & Low Bay Lighting

(ABV1-series)

Features

•

5 year limited warranty

• Damp location rated

Albeo

LED Luminaire

WARNING/AVERTISSEMENT

RISK OF ELECTRIC SHOCK

• Turn power off before inspection, installation or removal.

• Properly ground electrical enclosure.

RISK OF FIRE

• Follow all NEC and local codes.

• Use only UL or IEC approved wire for input/output connections.

Minimum size 18 AWG.

RISQUES DE DÉCHARGES ÉLECTRIQUES

• Coupez l’alimentation avant d’’inspecter, installer ou déplacer le luminaire.

• Assurez-vous de correctement mettre à la terre le boîtier d’alimentation électrique.

RISQUES D’INCENDIE

• Respectez tous les codes NEC et codes locaux.

• N’utilisez que des ls approuvés par UL ou IEC pour les entrées/sorties de

connexion. Taille minimum 18 AWG.

BEFORE YOU BEGIN

Read these instructions completely and carefully.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (A)/NMB-3(A)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the

interference at his own expense.

Save These Instructions

Use only in the manner intended by the manufacturer. If you have any questions, contact the manufacturer.

Prepare Electrical Wiring

Electrical Requirements

The LED driver must be supplied with 120-480 VAC, 50/60 Hz per product label and connected to an

individual properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker.

Grounding Instructions

The grounding and bonding of the overall system shall be done in accordance with National Electric

Code (NEC) Article 600 and local codes.

1 2 3 4

Resumo do Conteúdo

Página 1 - LED Luminaire

GELightingInstallation Guideimagination at workModular High & Low Bay Lighting(ABV1-series)Features•5 year limited warranty• Damp location ratedAl

Página 2 - Unit Installation

Carefully unpack unit and properly inspect for defects before installing. Wear work gloves to prevent dirt and oil from being transferred to the lumin

Página 3 - Optional Mounting Methods

13 42Loosen screws to remove power access plate.Connect AC line to xture’s power supply using thesupplied UL listed wire connectors. Green to green(g

Página 4 - Troubleshooting

ALB015-043014TroubleshootingSymptom SolutionLuminaire will not turn on. • Check that the color of the supply side wires match the color of the wires t