GE MN-ValVue-v2-8-IOM Manual de Serviço Página 94

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 93
ValVue Digital Communications Software Ver. 2.80
94
GE Oil & Gas
$$SWRev Software Revision
$$CmdRev Firmware Command Revision
$$PollingAddress PollingAddress
$$Position Position
$$Signal Input Signal
$$Pressure Actuator Pressure
$$IPOutput Signal to the I/P in Counts (0 - 65000)
$$Temperature Circuit Board Temperature
$$LowTemperature Historical Low Temperature
$$HighTemperature Historical High Temperature
$$Output Output from the process controller
$$Mode SVI II AP Mode
$$SignalPercent Input Signal as Percent
$$AirAction Air-to-Open/Air-to-Close
$$ActuatorType Single/Double Acting Actuator
$$PosErrorBand Position Error Band
$$PosErrorTime Position Deviation Time
$$Charact Characterization (Linear, Equal Percentage, etc.)
$$CustomCharact Displays the Custom Characterization constants
Individual items of the characterization curve may be selected by enter-
ing:
$$CustomCharact[n] - where n is a number between 0 and 17
$$ButtonLock Button Lock Level
$$Bumpless Bumpless Transfer On/Off
$$BumplessSpeed Time to move from Manual to Normal (operating) mode
$$TightShutoff Tight Shutoff On/Off
$$TSValue Tight Shutoff Value
Table 5 Report Setup Parameters (Continued)
Report Parameter Information Provided in Report
Vista de página 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 659 660

Comentários a estes Manuais

Sem comentários