GE JCS57 Manual do Utilizador descarregar pdf (Página 30)

GENEWL

To eliminatethe hward ofreaching overheated

surface elements, cabinets or storage spaces

should not be provided over a range.

Hcabinets are provided,the hward can be

reduced by insting a range hood that projects

hotiontily a minimumofWbeyond the bottom

ofthe cabinets.

men insta~ingthe range between base cabinets,

refer to figure belowfor the stie ofthe opening

needed. Do not seal the range to cabinets.

CA~ON: men unpacking the range, do not

discard the 4 shippingbolts as these are the

levelinglegs.

Ha service cord is used, the wdl receptacle

should be located in accordance with the

dimensions below.

/

+

7

m=

Y

The figure below shows the recommended

instigation relationship ofthe ranges to the

vertical walls ofthe surrounding structure.

Please note the following

N~:

1. The back ofthe range maybe instiled

directiy against the rear wdl of the structure.

2. These rangesconform to ULrequirements for

“Wspacingfrom the range to adjacentvertical

wallsabovethe countertop level.However,to

reduce possiblescorchingofverticalWWSand to

tilmke potentialfire hmards under abnormal

surface unit use conditionssuch ashigh heat or

no pans, a minimumof~ spacingshouldbe

providedon both sides ofthe cooktop.

3. To eliminatethe hward ofreaching over

heated surface units, cabinet storage space

located abovethe surface units should be

avoided.Ha cabinet is to be provided,the hward

can be reduced by instilling a range hood that

projects hotiontily a minimum ofWbeyond

the bottom ofthe mbinets.

N~: There is a minimum V clearance

required from the left side ofthe range to a wall.

This clearance is needed to open the left side

oven door or to remove the oven rack.

Not Less Than

-

\

\

11+=

DividedCooMop(40” Range)

See Note2

30

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Comentários a estes Manuais

Sem comentários